The cutting process described in this post is what I use from an operator’s perspective on the average project. Some project might have a different process and other operators may have a different way of working. It is not something that needs to be memorized from a certification and safe use perspective but may help lead to greater operator success.

Session Workflow

1. Startup – Use the checklist and make sure everything is working/filter uses etc.
2. Zero the bed – Also know as adjusting the z axis – How to guide
3. Position materials on the bed
4. Use the focus tool to drop the bed to the start focus point over your materials
5. Test fire a dot. Measure, note measurement, check for roundness in the dot – adjust as need – will need to do more adjustments the thicker the material.
6. Set up test cut file – using best-known power and speed settings do the first test cut
7. Test cut – Use troubleshooting tips and adjust speed, power, and focus until you get the results you desire. RECORD YOUR SETTINGS!! ( I take a lot of pictures)
8. Import your art into LaserSoft and apply the settings you just determined
9. Download the art to the laser
10. Verify positioning by using origin and running the box
11. Cut – pay attention especially during long runs
12. Shut down – Use the shutdown checklist