Author: crafty
Storage in Clean Fab
The bins in the far left section of the shelving unit shown below All goods must fit in a bin with the lids One bin per member Member may not take bins home All bins must be tagged
Storage In Textiles
Currently we don’t have any designated Basic Member Storage in Textiles, though members can use the Coworking Basic Member Storage.
Storage in Coworking
The brown wicker bins in the short black storage unit are considered basic member BIN storage. If your stuff can’t fit in a bin don’t put it there. Use ACE provided wicker bin One bin per member All goods must fit in your bin Do not take bins home All bins must be blue tagged
Workshop Storage for Members
The etiquette and situation with lumber and workshop project storage is complex but the policy is the same everywhere at ace. There are several designated Basic Member Storage areas in the Workshop: Scrappy/Horizontal Lumber Storage Sheet Goods Storage There is additional Storage In Suite #113 for Project Storage as well as a flex Area for …
Basic Member Storage in Suite #113
The shelves to the right of bike storage in #113 are considered basic member BIN storage. If your stuff can’t fit in a bin don’t put it there. Use ACE provided bin One bin per member All good must fit in your bin with the lid closed Do not take bins home All bins must …
How Storage Tags Work
We have Four types of tags used to manage stored goods at Ace Makerspace in dispensers in every room. Extra tags are stored on the grey cleaning supplies closet in suite #113 Storage. About Untagged Materials. Any materials that are not tagged in all member storage areas are considered fair game and available to all …
Laser Troubleshooting
Also see Laser FAQ Issue Possible solutions Bed is lower than zero but won’t move up any further when pushing the Z+ or doing a z-axis reset Drop the bed down about 30mm and it should now go up all the way (including doing a z-axis reset) Laser controller shows “X-axis cross-border” …
Cutting imported artwork
This is the very basic process for cutting imported art on the ACE Laser. Lasersoft accepts many file tips but likes simple SVG and DXF files best See Laser Troubleshooting or FAQ if your files will not import Process Set the parameters for your workspace. i.e. To set relative origin point – Click “Parameters”, then …
Basic Focus and Test Cutting
Set up the bed and materials Zero the Z – see How to raise and lower the bed (Z axis) Prepare your material for a test cut on the laser bed Jog laser head over to the material using arrow buttons to move a little bit, and hold down to move a lot. Use the …