Summary Needs to be cleaned on a regular basis. All hoses are connected with tension rings so take apart is easier than trying to wrestle aluminum tape on and off all the time. Logs
Author: David Perry
Team Laser Meeting Notes 9/28/22
September 28, 2022 Laser Team Meeting David, Miriam, Josh, Crafty Agenda New user shenanigans Not cleaning honeycomb Too much power Tell them to use less power when cutting Tips Of The Month DO not set speed to 1,000 on cut mode (this will not help saving time or money) …
Laser Parameter Settings
Open LaserSoft Check that the parameters are set to default and match the screen shots below NOTE: Only change the relative position for your job. NEVER change the machine zero. Check that the computer can see the laser. In the middle of the LaserSoft screen at the bottom it should say “Connected”. (See this post …
AMT352 High Precision Rotary Accessory for Laser
This rotary tool has a chuck style fitting similar to a lathe in order to accommodate many types of objects. It is a Light Object device. See Light Object Product Specification: There are two sets of jaws for the three jaws chuck. This rotary comes with a 3-phase stepper motor with 3 leads. 40cm travel …
Laser water chiller air filter cleaning
According to the LightObject 1600W Water Chiller instructions, we should be periodically cleaning the 2 filters on each side of the unit. With the unit off, use the two locking catches to remove one of the white metal side panels: The goal is to remove the black mesh frame from the white metal panel, start …
Laser keypad replacement
Over time, the exterior surface of keypad on the Barracuda laser starts to crack and break apart. Here’s a quick howto regarding replacement of the keypad. Open the laser tool kit, in the top you’ll find a padded envelope with a ribbon cable sticking out of it: Make 100% sure the laser is powered …