Make sure to follow all these steps before using the Ace laser cutter

1. Close Hallway Door then Turn On Honeywell Filter
2. Log into Laser Access Box by tapping your fob
3. Check the filter in the filter box
   1. Ensure that the filter type in the box matches the one on the Access Box screen
   2. Check that the filter you’re about to use looks OK, if it looks like it might be too used, replace it
4. Turn on system with Main Switch
5. Confirm air compressor is running with your foot
6. Confirm chiller is on and that the temperature is in the right range (19°-22°)
7. Do a draw test with the folded test paper
8. From the laser control panel, use the MENU button to reset the bed (Z-Axis reset)